Описание

  • Read head with guard locking without guard lock monitoring
  • Locking force 650 N
  • Adjustable adhesive force
  • Up to category 4 according to EN ISO 13849-1
  • Two safety screws M5x16 included
Adjustable adhesive force This version has an adhesive force also with the guard locking switched off. In this way it is intended, for example, to prevent the safety door opening due to vibration or similar. The adhesive force can be adjusted using a programming adapter to 70 N, 110 N or 150 N. Important:To change the preset adhesive force, you will need a programming adapter. Approach direction Typical operating distance Note assured switch-off distance sar = 20 mm for internal component failure. Safety outputs are reliably switched off. Dimension drawing Wiring diagram
Material
Read head Plastic (PPS)
Solenoid Steel, nickel-plated
Housing material Die-cast aluminum
Weight
Net 0,3 kg
Ambient temperature -25 ... 50 °C
Degree of protection IP67
Mechanical life
In case of use as door stop, and 1 Joule impact energy 1 x 106
Installation orientation Any
Switching frequency
Read head See operating instructions for the related evaluation unit
Solenoid max.1 Hz
Connection
X1, solenoid (yellow LED integrated in the plug) Plug connector M8x1, 4-pin male (with snap-action / screw terminal)
X3, read head Plug connector M8x1, 3-pin male (with snap-action / screw terminal)
Cable length max.25 m
Guard locking principle Open-circuit current principle
Locking force F
(Not monitored, in axial direction) at UCM?24V 650 N
Adhesive force
At UCM = 0V (default setting on delivery) 110 N
Programmable with adapter 70, 110, 150
Electrical connection ratings
Operating voltage DC
UCM 24 V DC -15% ... 10%
UB 24 V DC -15% ... 10%
Current consumption
On UCM at 24V 10 mA
On UB at UCM?0V 25 mA
On UB at UCM?24V 100 mA
Power consumption 2,8 W
Solenoid duty cycle 100 %
Work area
Switching hysteresis 0,7 mm
Assured switch-off distance Sar max.20 mm
Assured operating distance Sao min.2 mm
Center offset -2,5 ... +2,5 mm
''